| |
|
|
|
|
Products
|
|
|
|
|
|
|
|
|
|
|
|
 |
 |
 |
| |
A 75-Ohm terminator simply screws onto a standard F-connector, and presents a "load" to the system, as if a component were connected there. This is generally required with any type of diseqc or multi-switch which has unused ports.
"F" series terminators utilize passive electronic circuitry designed to block 60 cycle interference (generated by electric lines) and terminate RF signals on unused equipment ports. They are necessary to prevent impedance mismatches and minimize RF reflections and echoes. Unused active ports should always be terminated to:
- Prevent signal leakage
- Prevent extraneous signals from entering the system
- Prevent water and moisture damage if the unit is located outside
Note: This item comes in a pack of 100 pcs. If you are looking to purchase these connectors loose, they are available at $0.50/ea. |
|
|
|
|
 |
 |
 |
|
